| FA135913 | What is the start-up voltage drop limit considered by My Ecodial L. The acceptable limit for the startup voltage drop for the motor feeder is 15% as per the UTE standard (Installation standard - France)
the same is... |
| FA12081 | What is the Life Cycle Assessment (LCA) for the Multi9 product range. For Multi9 product ranges, Mean Time To Failure (MTTF) values is used for assessment of the product life cycle.
MTTF is the estimated reliability... |
| FA12038 | What is the naming convention for Vijeo Designer application. The following characters are valid characters that can be used for naming parts, devices, object, variables and passwords in Vijeo-Designer. a) Alphabet... |
| FA12141 | What is the heat dissipation of the Altivar 61 Drive when it is in Ready state. The heat dissipation value of the Altivar 61 Drives when in Ready State (RDY - Drive is powered up but motor is not running) depends on the size of... |
| FA12119 | What is the minimum recommended Ground to Input Phase insulation resistance for Altivar 71 Drive. The Insulation resistance value between Ground to Input Phase should be greater than 1 Mega Ohms which is the Megger value at 500 V for 1 minute. |
| FA12188 | What is the Short Circuit rating of LU2B starters in TeSys U as per UL508 TypeE specification. The Short Circuit rating of LU2B starters in TeSys U as per UL508 TypeE specification is as follows: Voltage (V AC) ... |
| FA11798 | What is the MTTF of Altivar 61 and Altivar 71. Refer the attachment for the data of Mean Time To Fail (MTTF) for Altivar 61 and Altivar71 Drives. |
| FA22640 | What is the difference between the SF6 technology and the Vacuum technology used in Schneider Make MV Circuit Breaker. SF6 and Vacuum are the two modern breaking techniques in the field of Medium Voltage. Refer the below table for the comparison of these two technologies:
... |
| FA22632 | Does Prisma Plus Switchboard confirm the Electrical continuity of moving parts. The Prisma Plus confirms the electrical continuity of moving parts as per IEC/EN 60439.1
Find attached the Declaration of Conformity for the same.
|
| FA12123 | What are the MTTF (Mean Time to Fail, in hours) values for Altivar 61/71 Drives. Refer the attachment for the Mean Time To Fail (MTTF) values for Altivar 61/71 Drives. Note: MTBF = Mean Time Between 2 Failures = MTTF + MTTRMTTR... |